Application Instructions

Surface Preparation: The surface must be free from grease and other residues, dry, smooth, and structurally sound. Check surfaces for paint bonding, damaged wallboard or plaster. Repair all unsound surfaces. Before proceeding with any unusual conditions, consult your adhesive or wallcovering supplier.

After completion of the required surface preparation, it is critical to test the surface with the adhesive to ensure compatibility. Select a small, inconspicuous area of the surface for testing and apply the adhesive as specified. Inspect the test area after 24 hours for any defects or inconsistencies before proceeding.

Dilution: Do not dilute.

Application Method: Product must be applied in climate-controlled conditions (ambient conditions: 59 to 77 degrees F, 30% to 50% humidity). Apply an even coat of adhesive with a notched 1/8 x1/8 x 7/16 metering trowel or 1/2-inch nap paint roller to deposit a minimum of 3 mils of adhesive. Allow adhesive to tack up for 3-5 minutes prior to installing wallcovering. Avoid contact with the face of the wallcovering.

Application Temperature: 59°F to 77°F

Clean-Up: Before the adhesive dries, remove any excess with clean water. Additional effort may be required if the adhesive is allowed to contact the surface of the material.

Warning

If you scrape, sand, or remove old paint, you may release lead dust. LEAD IS TOXIC. EXPOSURE TO LEAD DUST CAN CAUSE SERIOUS ILLNESS, SUCH AS BRAIN DAMAGE, ESPECIALLY IN CHILDREN. PREGNANT WOMEN SHOULD ALSO AVOID EXPOSURE. Wear a NIOSH-approved respirator to control lead exposure. Clean up carefully with a HEPA vacuum and a wet mop. Before you start, find out how to protect yourself and your family by contacting the National Lead Information Hotline at 1-800-424-LEAD or log on to www.epa.gov/lead.

Roman Products, LLC does not endorse the use of any product in an installation that does not meet a Class A fire rating or any applicable code. Testing by a certified laboratory should be conducted to verify that the installation meets a Class A fire rating and to guarantee compliance with all applicable codes. Specifically, if a Roman product is used to hang wallpaper over existing wallpaper, it is unlikely to meet these standards.

WARNING: This product can expose you to chemicals including crystalline quartz, which is known to the State of California to cause cancer. For more information go to www.P65Warnings.ca.gov.

Limited Warranty

ROMAN Products, LLC warrants that it will replace this product free of charge, if, within 12 months of manufacture, it is found to be defective in material or workmanship. This warranty is in lieu of any other. The exclusive remedy is limited to the replacement of the product and ROMAN disclaims all liability for consequential, punitive, and special damages. Conditions of use are beyond our control.

Caution

Store in a cool, dry place. Do not take internally. In case of ingestion, seek medical attention. Avoid contact with skin and eyes. Use of skin and eye protection is recommended at all times. If contact with eye occurs, flush with water for 15 minutes. If skin contact occurs, wash with soap and water. Seek medical attention if rash or other symptoms occur. Do not mix with other chemicals. Use in a well-ventilated work area. Close container after each use. Keep out of reach of children.

Specialty Construction Adhesives

PRO-515 Ultra® All-Purpose, All-Surface Construction Adhesive Kit

PRO-510 Multi-Purpose Advanced Construction Adhesive

PRO-515 Ultra® All-Purpose, All-Surface Construction Adhesive